The switch had 2 retaining lugs that had to be pushed in to get it out....Trouble was one you could not see or get to....
I just freed one side and wiggled and forced it out.......
► Show Spoiler
- tm15.JPG (250.81 KiB) Viewed 2785 times
I then put the new switch in......The switch has a locating ridge so it will only go in one way.....When I got it lined up and pushed it in there was no movement at all in the switch body, it was as snug as a bug, which is why I wonder about the hot glue.....
I then refixed the PCB, making sure not to trap any wires.......
► Show Spoiler
- tm16.JPG (253.45 KiB) Viewed 2785 times
I attached the connectors and just for good measure put a cable tie back.....I did not bother with the lower on as I could see no harm in leaving it off......
► Show Spoiler
- tm17.JPG (249.85 KiB) Viewed 2785 times
T.B.C